Tribute 2WD V6-3.0L (2008)
7. Install the lower LH center instrument panel finish panel.
-
Attach the 2 retainer hooks to the instrument panel brace.
-
Install the pin-type retainer.
8. Install the floor center console.
9. Repower the system. See SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING.
10. When installing a new RCM, carry out the steps necessary to complete programmable module installation (PMI). See MODULE
CONFIGURATION. See: Body and Frame/Body Control Systems/Testing and Inspection/Programming and Relearning
11. Prove out the supplemental restraint system (SRS) as follows:
Turn the ignition switch from ON to OFF. Wait 10 seconds, then turn the ignition switch back to ON and visually monitor the air bag indicator
with the air bag modules installed. The air bag warning indicator will light continuously for approximately 6 seconds and then turn OFF. If an air
bag SRS fault is present, the air bag warning indicator will:
-
fail to light.
-
remain lit continuously.
-
flash at a 5 Hz rate (RCM not configured).
The air bag warning indicator might not light until approximately 30 seconds after the ignition switch has been turned from the OFF to the ON
position. This is the time required for the RCM to complete the testing of the SRS. If the air bag indicator is inoperative and a SRS fault exists, a
chime will sound in a pattern of 5 sets of 5 beeps. If this occurs, the air bag warning indicator and any SRS fault discovered must be diagnosed and
repaired.
Clear all continuous diagnostic trouble codes (DTCs) from the RCM.
