Tribute 2WD V6-3.0L (2008)
8. Bend the retaining tab away from the pressure sensor, then slide the pressure sensor off the bracket.
9. Remove the 2 rivets and the OCS ECU.
CAUTION: Care must be taken to prevent damage to the seat cushion pan when removing the rivets.
10. Remove the 2 pin-type retainers from the OCS bladder and seat cushion pan.
11. Feed the OCS hose and pressure sensor through the seat cushion pan opening and remove as an assembly with the bladder.
Installation
NOTE: If installing an OCS service kit.
1. Bend the retaining tab back on the pressure sensor component bracket.
2. Feed the OCS components (pressure sensor and hose) through the seat cushion pan opening.
WARNING: Inspect the occupant classification sensor bladder, seat cushion pan and support assembly for any foreign objects, before
installing the occupant classification sensor to the seat cushion pan. If any foreign objects are found, remove them. Failure to do so may
result in personal injury, in the event of an air bag deployment.
