Tribute 2WD V6-3.0L (2008)
1. Connect the seat wire harness OCS electrical connector to the service part OCS electrical connector.
2. Install the two wiring clips on the wiring harness to the cushion pan.
3. If equipped with heated seats, connect the heated seat module electrical connector, install the wiring clip on the wiring harness to the cushion
pan, and connect the two cushion element electrical connectors.
4. Tie strap the unused seat wire harness pressure sensor electrical connector safely out of the way.
5. Tie strap all loose wire harnesses and electrical connectors safely out of the way.
8. Install the passenger seat into the vehicle.
9. Repower the system. Do not prove out the system at this time. See SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND
REPOWERING.
10. With the front passenger seat empty, use a scan tool to trigger the active command.
WARNING: Make sure the front passenger seat repair is complete, the seat is completely assembled, all components (head restraint, seat
side shield, etc.) are correctly installed and the front passenger seat is correctly installed to the vehicle before carrying out the OCS
system reset. Failure to follow these instructions may result in incorrect operation of the OCS system and increase the risk of serious
personal injury or death in a collision.
CAUTION:
-
Make sure the seat is completely assembled before carrying out the occupant classification sensor (OCS) system reset active
command. Failure to follow these instructions may result in incorrect operation of the OCS system and may cause system failure.
-
The following precautions must be taken before carrying out the occupant classification sensor (OCS) system reset. Failure to
follow these instructions may result in incorrect operation of the OCS system and may cause system failure.
-
Make sure the OCS system components are connected and no faults are present.
-
Make sure the OCS system is not at a temperature below 0 °C (32 °F) or above 45 °C (113 °F) when initiating the rezeroing
process. If the vehicle has been exposed to extreme cold or hot temperatures, the vehicle must be exposed and kept at a
temperature within the limits, 0 °C to 45 °C (32 °F to 113 °F) for a minimum of 30 minutes.
-
Make sure nothing is present on the passenger seat before carrying out the OCS system reset and nothing is placed on the seat
during the process.
-
Make sure a minimum 8-second time period has passed after cycling the ignition switch ON before the carrying out the OCS
system reset process.
NOTE:
-
For best results in carrying out the occupant classification sensor (OCS) system reset process, the OCS system should be at or near room
temperature, 10 °C to 29 °C (50 °F to 85 °F).
-
If the first attempt to carry out the occupant classification sensor (OCS) system reset is unsuccessful and DTC C1941 is reported, a second
attempt must be made. If on the second attempt to carry out the OCS system reset is unsuccessful and DTC C1941 is reported a second
