Tribute 2WD V6-3.0L (2008)
7. Tighten the tie-rod end jam nut(s) to 40 N-m (4.0 kgf-m, 30 ft-lbf).
Caution
^
Hold the tie-rod end stationary with a wrench while tightening the nut, or damage to the boot can occur.
Note
^
Do not disturb the toe settings while tightening the nut(s).
8. Install the steering gear bellows clamp(s).
9. Check the toe settings. Follow the equipment manufacturer's instructions.
Camber and Caster Adjustment
CAMBER AND CASTER ADJUSTMENT
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the 4 front strut upper mounting bracket nuts.
3. Push the front strut mounting bracket downward and turn it to the desired position to set the camber and caster. Both camber and caster for the
front suspension are adjustable. See Steps 4 and 5.
4. Use the following table for LH side camber and or caster adjustment.
