Tribute 2WD V6-3.0L (2008)
10. Open and lower the glove compartment door.
11. Remove the 2 passenger air bag module bolts.
12. Through the glove compartment opening, release the passenger air bag module deployment door clips while pushing the passenger air bag module
out of the I/P.
CAUTION: Do not handle the passenger air bag module by grabbing the edges of the deployment door. Failure to follow this instruction
may result in vehicle damage, equipment damage, component damage and/or system failure.
NOTE: Use care when removing the passenger air bag module from the instrument panel (I/P). The passenger air bag module can drop down
during removal and the passenger air bag module rear bracket can scratch the front of the I/P
13. Remove the passenger air bag module.
1. Disconnect the 2 passenger air bag module electrical connectors.
2. Detach the wire harness routing clip and remove the passenger air bag module.
