Tribute 2WD V6-3.0L (2008)
Drive/Propeller Shaft: Service and Repair
DRIVESHAFT REMOVAL/INSTALLATION
Driveshaft
Warning
^
The normal operating temperature of the exhaust system is very high. Never attempt to remove any part of the system until it has cooled.
Be especially careful when working around the catalytic converters. The temperature of the converter rises to a high level after only a few
minutes of engine operation. Failure to follow these instructions may result in personal injury.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the ground strap bolt.
^
To install, tighten to 40 N-m {4.1 kgf-m, 30 ft-lbf}.
3. Remove and discard the 6 front driveshaft-to-transfer case bolts and washers.
^
To install, tighten to 40 N-m {4.1 kgf-m, 30 ft-lbf}.
Caution
