Tribute 2WD V6-3.0L (2008)
Windshield Washer Pump: Service and Repair
Windshield Washer Pump Removal/Installation
WINDSHIELD WASHER PUMP REMOVAL/INSTALLATION
1. With the vehicle in NEUTRAL, position it on a hoist. See LIFTING.
2. Remove the RH front fender splash shield.
3. Disconnect the washer pump electrical connector.
4. Disconnect the front and rear washer pump hoses.
-
Spread the clip apart to release the lock and pull the hose assembly from the pump.
-
To install, make sure the hoses are fully seated and locked in place.
WARNING: Windshield washer solution contains methanol, which is poisonous. Observe all cautions and warnings indicated on the
label of the washer solution container. Failure to follow these instructions may result in personal injury.
NOTE: To prevent spilling windshield washer fluid, drain the windshield washer reservoir before washer pump removal.
5. Remove the washer pump.
CAUTION: When installing a new washer pump, be careful not to damage the rubber grommet.
6. To install, reverse the removal procedure.
-
Fill the windshield washer reservoir with windshield washer fluid.
WARNING: Windshield washer solution contains methanol, which is poisonous. Observe all cautions and warnings indicated on the
label of the washer solution container. Failure to follow these instructions may result in personal injury.
CAUTION: Do not operate the washer pump prior to filling the windshield washer reservoir. Failure to follow these instructions may
result in premature pump failure.
