Tribute 4WD L4-2.3L Hybrid (2008)
Rear Bumper Cover / Fascia: Service and Repair
REAR BUMPER COVER REMOVAL/INSTALLATION
1. Remove the 2 rear bumper cover lower screws (1 each side).
-
To install, tighten to 5 Nm {0.5 kgf-m, 44 in-lbf}.
2. Remove the 4 rear bumper cover center screws.
3. Remove the 2 rear bumper cover lower pushpins.
4. Remove the 2 rear splash shield-to-rear bumper cover screws (1 each side).
5. Remove the 2 rear bumper cover upper screws (1 each side).
-
To install, tighten to 5 Nm {0.5 kgf-m, 44 in-lbf}.
6. Remove the 2 liftgate alignment bumper bolts and the 2 liftgate alignment bumpers.
-
To install, tighten to 8 Nm {0.8 kgf-m, 71 in-lbf}.
7. Disconnect the trailer tow electrical connector, if equipped.
8. Remove the rear bumper cover.
9. To install, reverse the removal procedure.
-
When installing, position the rear bumper cover into the bumper slides.
