Tribute 4WD L4-2.3L Hybrid (2008)
-
Disconnect and detach the safety belt buckle pretensioner and buckle switch electrical connectors from the seat track.
-
Detach the wiring harness pin-type retainer.
-
Route the wiring harness from between the seat track and cushion frame.
4. Detach the seat harness electrical connector and wiring harness from the seat track.
NOTE: Note wiring harness routing for installation.
5. Remove the 4 front seat track bolts.
-
To install, tighten to 23 Nm {2.3 kgf-m, 17 ft-lbf}.
Heated seat
1. Disconnect and detach the cushion heater mat electrical connector.
2. Release the locking tab and remove the heated seat relay from the bracket on the cushion frame.
3. Disconnect the heated seat relay electrical connector.
Seat with an original equipment OCS
1. Disconnect the electrical connectors and wiring clips.
a. Disconnect the OCSM electrical connector.
b. Disconnect the pressure sensor electrical connector.
i.
Release the 2 wiring clips on the wiring harness from the cushion frame.
WARNING: Install a new OCS system service kit as a complete assembly. Never install only part of the kit components. Failure to follow this
instruction may result in incorrect operation of the OCS system and increases the risk of serious personal injury or death in a crash.
NOTE: To identify between a production OCS system and a OCS system service kit, inspect the OCSM electrical connector. A production OCS system
allows the disconnection of the OCSM electrical connector.An OCS system service kit has the electrical connector glued to the module. It cannot and
should not be disconnected or altered.
