Tribute 4WD L4-2.3L Hybrid (2008)
2. Release the cushion trim cover retainers and remove the cushion trim cover.
-
Separate the hook-and-loop strips.
CAUTION: Use care when separating the seat cushion trim cover from the hook-and-loop strips or the hook-and-loop strips may be torn from the seat
cushion foam pad.
3. Remove the cushion foam pad.
4. Bend the retaining tab away from the pressure sensor, then slide the pressure sensor off the bracket.
5. Remove the 2 rivets and the OCSM.
CAUTION: Care must be taken to prevent damage to the seat cushion frame when removing the rivets.
6. Remove the 2 pin-type retainers from the OCS bladder and seat cushion frame.
7. Feed the OCS hose and pressure sensor through the seat cushion frame opening and remove as an assembly with the bladder.
Seat with an OCS system service kit
1. Disconnect the electrical connector and wiring clips.
a. Disconnect the seat wire harness OCSM electrical connector from the service part OCS electrical connector.
b. Release the 2 wiring clips on the wiring harness from the cushion frame.
