Tribute 4WD L4-2.3L Hybrid (2008)
13. Remove the A/C tube bracket-to-HCU.
-
To install, tighten to 6 Nm {0.6 kgf-m, 53 in-lbf}.
14. Remove the HCU assembly.
15. Remove the 3 HCU grommets.
NOTE: When installing, use a suitable lubricant.
16. To install, reverse the removal procedure.
-
Bleed the brake system. See - See: Brake Bleeding/Service and Repair/Brake System Bleeding.
NOTE: Use care not to cross the tubes during installation. If the brake tubes are crossed, the ABS module will set DTCs during an ABS event.
