Tribute 4WD L4-2.3L Hybrid (2008)
2. Remove the air cleaner and the air cleaner outlet pipe. See - See: Powertrain Management/Fuel Delivery and Air Induction/Intake Air
Duct/Service and Repair/Air Cleaner Outlet Pipe Removal/Installation or - See: Powertrain Management/Fuel Delivery and Air Induction/Intake
Air Duct/Service and Repair/Air Cleaner Outlet Pipe Removal/Installation.
3. Disconnect the master cylinder brake tube fittings from the hydraulic control unit (HCU).
-
To install, tighten to 23 Nm {2.3 kgf-m, 17 ft-lbf}.
Vehicles with 3.0L (4V) engine
1. Disconnect the master cylinder brake tube fittings from the master cylinder and remove the brake tubes.
-
To install, tighten to 23 Nm {2.3 kgf-m, 17 ft-lbf}.
All vehicles
1. Disconnect the front brake tube fittings from the HCU.
-
To install, tighten to 15 Nm {1.5 kgf-m, 11 ft-lbf}.
NOTE: The brake tubes must be installed in the same location as removed.
2. Disconnect the rear brake tube fittings from the jumper tubes.
-
To install, tighten to 15 Nm {1.5 kgf-m, 11 ft-lbf}.
3. Disconnect the electrical connector by rotating the protective cover.
4. Remove the 3 HCU bracket-to-frame bolts and remove the HCU.
-
To install, tighten to 20 Nm {2.0 kgf-m, 15 ft-lbf}.
5. To install, reverse the removal procedure.
-
Bleed the brake system. See See: Brake Bleeding/Service and Repair/Brake System Bleeding.
