Tribute 4WD L4-2.3L Hybrid (2008)
6. Loosen the clamp and remove the brake fluid low pressure feed hose.
-
To install, tighten to 3 Nm {0.3 kgf-m, 27 in-lbf}.
7. Loosen the clamp and remove the brake fluid low pressure return hose.
-
To install, tighten to 3 Nm {0.3 kgf-m, 27 in-lbf}.
8. Disconnect the brake tube-to-HCU fittings (10 mm).
-
To install, tighten to 18 Nm {1.8 kgf-m, 13 ft-lbf}.
NOTE: Note the order of the brake tubes.
9. Disconnect the brake tube-to-HCU fittings (12 mm).
-
To install, tighten to 18 Nm {1.8 kgf-m, 13 ft-lbf}.
NOTE: Note the order of the brake tubes.
10. Remove the 2 ground wire nuts and position the 2 ground wires aside.
-
To install, tighten to 12 Nm {1.2 kgf-m, 9 ft-lbf}.
11. Remove the 3 HCU bracket-to-frame studs.
-
To install, tighten to 30 Nm {3.0 kgf-m, 22 ft-lbf}.
12. Disconnect the brake tube from the routing clip located at the bottom of the HCU bracket.
