Tribute 4WD L4-2.3L Hybrid (2008)
1. Remove the hydraulic control unit (HCU). See See: Antilock Brakes / Traction Control Systems/Hydraulic Control Assembly - Antilock
Brakes/Service and Repair/Hydraulic Control Unit (HCU) Removal/Installation.
2. Remove the jumper tube assembly bracket nut.
-
To install, tighten to 9 Nm {0.9 kgf-m, 80 in-lbf}.
3. Disconnect the jumper tubes fittings from the HCU and remove the jumper tube assembly.
-
To install, tighten to 15 Nm {1.5 kgf-m, 11 ft-lbf}.
4. Remove the 4 ABS module screws and the ABS module.
-
To install, tighten to 2 Nm {0.2 kgf-m, 18 in-lbf}.
5. To install, reverse the removal procedure.
6. Configure the ABS module. See See: Testing and Inspection.
7. Calibrate the ABS module. Follow the instructions on the scan tool.
NOTE: Vehicle must be on level ground and at a complete stand still during calibration.