Tribute 4WD L4-2.3L Hybrid (2008)
Acceleration/Deceleration Sensor: Service and Repair
STABILITY CONTROL SENSOR CLUSTER REMOVAL/INSTALLATION
WARNING: The traction battery and charging system contain high voltage components and wiring. High voltage insulated safety gloves and a face
shield must be worn when carrying out any diagnostics on this vehicle. Failure to follow these instructions may result in serious personal injury or death.
1. Remove the floor console. See See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair.
2. Disconnect the electrical connector.
NOTE: When installing the accelerometer the electrical connector must face the passenger seat.
3. Remove the 2 sensor cluster bolts.
-
To install, tighten to 10 Nm {1.0 kgf-m, 89 in-lbf}.
4. Remove the sensor cluster.
5. To install, reverse the removal procedure.