Tribute 4WD L4-2.3L Hybrid (2008)
Braking Sensor/Switch: Service and Repair
BRAKE PEDAL POSITION (BPP) SWITCH REMOVAL/INSTALLATION
CAUTION: Do not service the brake pedal, brake booster, or master cylinder without first removing the stoplamp switch. Do not install the stoplamp
switch without the brake pedal arm secured to the brake booster push rod. Do not press or pull on brake pedal when installing or removing the stoplamp
switch otherwise misadjustment or damage to the stoplamp switch could occur.
1. Remove the stoplamp switch.
-
Disconnect the electrical connector.
NOTE: Rotate the stoplamp switch clockwise approximately 1/8 turn to remove.
2. To install, reverse the removal procedure.
