Tribute 4WD L4-2.3L Hybrid (2008)
-
When removing the body grommet, rotate the grommet into a position which allows the use of a small screwdriver to release the tabs on the
underside of the body grommet. These 2 tabs are located at right angles to the sensor wire.
CAUTION: Care must be taken during the removal of the grommet to prevent damage. If the grommet is damaged, a new sensor may need to be
installed, even though the sensor is functional in all other aspects.
4. Remove the front wheel speed sensor harness from the retainer.
5. Remove the front wheel speed sensor harness-to-body bolt.
-
To install, tighten to 9 Nm {0.9 kgf-m, 80 in-lbf}.
6. Remove the front wheel speed sensor harness bolt.
-
To install, tighten to 15 Nm {1.5 kgf-m, 11 ft-lbf}.
7. Remove the front wheel speed sensor bolt from the wheel knuckle.
-
To install, tighten to 9 Nm {0.9 kgf-m, 80 in-lbf}.
NOTE: Clean off any foreign material that may have collected around the sensor before removal.
8. Remove the front wheel speed sensor.
9. To install, reverse the removal procedure.
NOTE: Thoroughly clean the mounting surface.
Front Wheel Speed Sensor Ring
