Tribute 4WD L4-2.3L Hybrid (2008)
1. Press the locking tab and rotate the speed control cable cap to remove.
2. Disconnect the speed control cable from the speed control actuator pulley.
a. Gently push the retaining spring.
b. Disconnect the speed control cable slug from the speed control actuator pulley.
3. Remove the 3 speed control actuator screws and the speed control actuator.
-
Disconnect the electrical connector.
Installation
1. Install the speed control actuator and the 3 speed control actuator screws.
-
Tighten to 9 Nm {0.9 kgf-m, 80 in-lbf}.
-
Connect the electrical connector.
CAUTION: A new speed control cable must be installed.
