Tribute 4WD L4-2.3L Hybrid (2008)
-
Stage 2: Tighten an additional 90 degrees (1/4 turn).
CAUTION: The crankshaft must remain in the top dead center (TDC) position during installation of the pulley bolt or damage to the engine can occur.
Therefore, the crankshaft pulley must be held in place with the special tool and the bolt should be installed using hand tools only.
NOTE: Do not reuse the crankshaft pulley bolt.
6. Remove the 6 mm (0.23 in) x 18 mm (0.7 in) bolt.
7. Remove the special tool.