Tribute 4WD L4-2.3L Hybrid (2008)
Drive Belt Tensioner: Service and Repair
-
ACCESSORY DRIVE BELT TENSIONER REMOVAL/INSTALLATION - HYBRID
1. With the vehicle in NEUTRAL, position it on a hoist. See See: Maintenance/Vehicle Lifting/Service and Repair/Lifting.
2. Remove the pin-type retainer, 5 bolts and the RH splash shield.
-
To install, tighten to 9 Nm {0.9 kgf-m, 80 in-lbf}
3. Rotate the accessory drive belt tensioner clockwise and remove the accessory drive belt.
4. Remove the 3 bolts and the accessory drive belt tensioner.
-
To install, tighten to 25 Nm {2.5 kgf-m, 18 ft-lbf}.
5. To install, reverse the removal procedure.