Tribute 4WD L4-2.3L Hybrid (2008)
4. Release the clamp and disconnect the auxiliary coolant pump-to-thermostat hose.
5. Release the clamp and disconnect the heater outlet hose.
6. Disconnect the auxiliary coolant flow pump electrical connector.
7. Remove the 2 auxiliary coolant flow pump bolts and the auxiliary coolant flow pump.
-
To install, tighten to 4 Nm {0.4 kgf-m, 35 in-lbf}.
8. Remove the auxiliary coolant flow pump and rubber bracket assembly.
9. To install, reverse the removal procedure.
-
Fill the engine cooling system. See - See: Engine, Cooling and Exhaust/Cooling System/Coolant/Service and Repair/Removal and
Replacement or - See: Engine, Cooling and Exhaust/Cooling System/Coolant/Service and Repair/Removal and Replacement.
NOTE: Lubricate the coolant hoses with plain water only if needed. Do not use soap or other detergents.
