Tribute 4WD L4-2.3L Hybrid (2008)
Hose/Line HVAC: Service and Repair
Evaporator Outlet Line Removal/Installation
-
EVAPORATOR OUTLET LINE REMOVAL/INSTALLATION - HYBRID
NOTE: Installation of a new suction accumulator is not required when repairing the air conditioning system, except when there is physical evidence of
contamination from a failed A/C compressor or damage to the suction accumulator.
1. Recover the refrigerant. See See: Service and Repair/Discharging And Recovery.
2. Disconnect the low-charge protection switch electrical connector.
3. Remove the evaporator outlet line fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm {1.5 kgf-m, 11 ft-lbf}.
4. Remove the thermostatic expansion valve (TXV) fitting nut and disconnect the fitting.
-
Discard the gasket seals.
-
To install, tighten to 15 Nm {1.5 kgf-m, 11 ft-lbf}.
5. Detach the evaporator outlet line from the A/C line bracket.
6. Remove the evaporator outlet line.
7. To install, reverse the removal procedure.
-
Install a new O-ring and new gasket seals.
