Tribute 4WD L4-2.3L Hybrid (2008)
7. Remove the 2 evaporator outlet line fitting nuts.
-
Discard the O-ring seals and gasket seals.
-
To install, tighten to 15 Nm {1.5 kgf-m, 11 ft-lbf}.
8. Remove the compressor manifold and tube assembly bracket nut.
-
To install, tighten to 8 Nm {0.8 kgf-m, 71 in-lbf}.
9. Remove the compressor manifold and tube assembly.
10. To install, reverse the removal procedure.
-
Install new gasket seals and O-ring seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil. See See: Service and Repair/Refrigerant Oil Adding.
11. Evacuate, leak test and charge the refrigerant system. See See: Service and Repair/Air Conditioning (A/C) System Evacuation And Charging.
