Tribute 4WD L4-2.3L Hybrid (2008)
1. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
2. Verify the 12-volt battery condition. Carry out the battery condition test. See See: Starting and Charging/Battery/Testing and Inspection/Pinpoint
Tests/Pinpoint Test 6: Battery Condition Test
3. If the cause is not visually evident, connect the scan tool to the data link connector (DLC).
NOTE: Make sure to use the latest scan tool software release.
4. If the scan tool does not communicate with the VCM:
-
Check the VCM connection to the vehicle.
-
Check the scan tool connection to the VCM.
-
See - See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Pinpoint Tests/CAN Communication
Network/Pinpoint Test 17: No Power To The Scan Tool.
NOTE: The vehicle communication module (VCM) LED prove out confirms power and ground from the DLC are provided to the VCM.
5. If the scan tool does not communicate with the vehicle:
-
Verify the ignition key is in the ON position.
-
Verify the scan tool operation with a known good vehicle.
-
See - See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Pinpoint Tests/CAN Communication
Network/Pinpoint Test 1: The PCM Does Not Respond To The Scan Tool Or No High Speed Controller Area Network (HS-CAN)
Communication.
6. Carry out the network test.
