Tribute 4WD L4-2.3L Hybrid (2008)
Disassembly
CAUTION: Tire pressure sensors are manufactured in multiple colors based on their application. When installing a new sensor, make sure the color of
the sensor being installed matches the color of the sensor that was removed. The different colored sensors are not interchangeable.
NOTE: The sensor is available separately, the cradle and strap are available as a strap kit. There are several different strap kits available based on wheel
diameter but all strap kits share the same base part number.
NOTE: Tire pressure sensors are equipped with lithium-ion batteries and must be disposed of accordingly.
1. Remove the tire pressure monitoring system (TPMS) sensor. See See: Tire Pressure Monitoring System (TPMS) Sensor Removal/Installation.
2. Remove a factory installed strap in the following sequence:
a. Locate the strap buckle and secure the strap to the wheel using duct tape or a similar item, on both sides of the buckle approximately 25 mm
(0.98 in) from the buckle.
b. Using a large screwdriver and a twisting motion, unbuckle the strap.
c. Discard the strap.
WARNING: The TPMS band is under tension. Always use safety goggles or a face shield and gloves when removing the TPMS band/strap. Failure to
follow these instructions may result in personal injury.
3. To remove a dealer installed strap, turn the worm gear screw until the strap is fully released from the worm gear.
-
Discard the strap.
4. Using a screwdriver, or similar tool, remove the cradle by inserting the screwdriver under the cradle and prying up.
NOTE: To aid assembly, mark the location of the cradle prior to disassembly.
Assembly
1. Position the sensor into the new cradle by inserting the hinge end of the sensor into the hook end of the cradle and pushing the opposite end of the
sensor down onto the cradle.
NOTE: Make sure the sensor is fully seated into the new cradle. The sensor will make a "click" noise when fully seated.
