Tribute 4WD L4-2.3L Hybrid (2008)
5. Connect the small RCM electrical connector and push the lock tab in.
6. Position back the carpet on the LH and RH tunnel to its original position.
7. Install the lower LH center instrument panel finish panel.
-
Attach the 2 retainer hooks to the instrument panel brace.
-
Install the pin-type retainer.
8. Position the carpet into place and install the 2 front LH floor console screws.
9. Repower the system. See See: Air Bag(s) Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering And
Repowering.
10. When installing a new RCM, carry out the steps necessary to complete programmable module installation (PMI). See See: Testing and Inspection.
11. Prove out the supplemental restraint system (SRS) as follows:
Turn the ignition switch from ON to OFF. Wait 10 seconds, then turn the ignition switch back to ON and visually monitor the air bag indicator
with the air bag modules installed. The air bag warning indicator will light continuously for approximately 6 seconds and then turn OFF. If an air
bag SRS fault is present, the air bag warning indicator will:
- fail to light.
- remain lit continuously.
- flash at a 5 Hz rate (RCM not configured).
The air bag warning indicator might not light until approximately 30 seconds after the ignition switch has been turned from the OFF to the ON
position. This is the time required for the RCM to complete the testing of the SRS. If the air bag indicator is inoperative and a SRS fault exists, a
chime will sound in a pattern of 5 sets of 5 beeps. If this occurs, the air bag warning indicator and any SRS fault discovered must be diagnosed and
repaired.
Clear all continuous diagnostic trouble codes (DTCs) from the RCM.
