Tribute 4WD L4-2.3L Hybrid (2008)
1. With the vehicle in NEUTRAL, position it on a hoist. See See: Maintenance/Vehicle Lifting/Service and Repair/Lifting.
2. Remove the rear wheel hub nut.
-
To install, tighten to 290 Nm {29.0 kgf-m, 214 ft-lbf}.
3. Remove the sensor ring from the wheel hub.
4. To install, reverse the removal procedure.
All wheel drive (AWD) vehicles
1. The rear wheel speed sensor ring is integral to the rear axle halfshaft and cannot be repaired separately. See See: Transmission and
Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Rear Axle / Rear Drive Halfshafts Removal/Installation.
