Tribute 4WD L4-2.3L Hybrid (2008)
CAUTION: While positioning the seat cushion pan and occupant classification sensor assembly, be careful not to damage any of the components.
Failure to do so can result in component failure.
6. Detach the seat cushion trim cover J-clips from the seat cushion pan and remove the seat cushion trim cover.
CAUTION: Use care when separating the seat upholstery from the hook-and-loop strip, or the hook-and-loop strip can be torn from the seat cushion
foam pad.
7. Remove the seat cushion foam pad.
8. Bend the retaining tab away from the pressure sensor, then slide the pressure sensor off the bracket.
9. Remove the 2 rivets and the OCS ECU.
CAUTION: Care must be taken to prevent damage to the seat cushion pan when removing the rivets.
10. Remove the 2 pin-type retainers from the OCS bladder and seat cushion pan.
11. Feed the OCS hose and pressure sensor through the seat cushion pan opening and remove as an assembly with the bladder.
Installation
CAUTION: To prevent system failure, it is necessary to carry out the Occupant Classification Sensor (OCS) system reset when a front passenger seat
cushion is disassembled, a new trim cover installed or an OCS system service kit is installed. A scan tool is used to carry out the OCS system reset
command.
