Tribute 4WD L4-2.3L Hybrid (2008)
2. Clean the area where the sensor and cradle are to be installed.
CAUTION: Metal scrapers can damage the wheel. Use only plastic or non-metallic scrapers to remove the cradle adhesive strip residue.
NOTE: The sensor and cradle must be installed in the drop well of the wheel, 180 degrees from the valve stem.
3. Remove the adhesive tape liner from the cradle and position the sensor and cradle into the wheel drop well 180 degrees from the valve stem.
NOTE: The sensor and cradle must be positioned with the hinge side of the sensor on the RH side when viewed from the curb side (beauty side) of the
wheel.
NOTE: The sensor has raised markings indicating how to position the sensor.
