Tribute 4WD L4-2.3L Hybrid (2008)
4. Install the tapered end of the strap through the opening of the cradle on the hinge side of the sensor. This will position the worm gear on the
locking clip side of the sensor.
5. Position the worm gear 13-26 mm {0.5-1.0 in} away from the sensor and tighten the worm gear.
-
Tighten to 3 Nm {0.3 kgf-m, 27 in-lbf}.
CAUTION: Steel wheels have a "high spot" along their circumference. Make sure the strap is positioned in the lowest spot possible for correct sensor
and cradle retention.
NOTE: Keep the strap parallel with the wheel flange while tightening the worm gear.
6. Install the tire onto the wheel. See See: Tires/Service and Repair.
CAUTION: The sensor, cradle and strap can be damaged by incorrect tire mounting or dismounting. Mount the tire only as instructed.
7. Train the tire pressure sensor(s). See See: Testing and Inspection/Programming and Relearning/Tire Pressure Monitoring System (TPMS) Sensor
Training.
NOTE: A new tire pressure sensor is shipped in an OFF mode (or battery saver mode) and must be turned ON before it can be trained. To turn the
sensor ON, inflate the tire to the recommended inflation pressure and wait at least 2 minutes, then continue with the sensor training procedure.
