Tribute 4WD L4-2.3L Hybrid (2008)
4. Rotate the flange 90 degrees clockwise.
NOTE: Index-mark the shaft for reference.
5. Connect the front driveshaft and install the 6 new bolts and 3 new washers.
-
Tighten to 40 Nm {4.0 kgf-m, 30 ft-lbf}.
6. Disconnect the rear driveshaft U-joint flange.
-
Discard the 4 bolts.
CAUTION: Do not reuse the bolts for the pinion yoke. Install new bolts or damage to the vehicle may occur.
