Tribute 4WD L4-2.3L Hybrid (2008)
10. Using the special tool, distance the windshield glass from the body.
11. Using the special tool, cut the remaining urethane adhesive and remove the windshield glass.
12. Using a soft brush or vacuum, remove any foreign material or dirt from the pinch weld.
Installation
WARNING: Do not drive vehicle until the urethane seal has cured. Follow urethane manufacturer's curing directions. Inadequate or incorrect curing of
the urethane seal will adversely affect glass retention. Failure to follow these instructions may result in serious injury to vehicle occupant(s).
CAUTION: Open the windows to prevent the windshield glass from being pushed out by air pressure if the doors are closed.
WARNING: Open the windows to prevent the windshield glass from being pushed out by air pressure if the doors are closed.
1. Dry fit the windshield glass, making alignment marks with tape or a non-staining grease pencil.
2. Trim the remaining urethane adhesive on the pinch weld to within the specification.
-
The existing urethane adhesive surface should be smooth and free of cuts and contamination.
WARNING: Repair any corrosion found on the pinch weld. The pinch weld is a structural component of the vehicle. Corrosion left unrepaired may
reduce the structural integrity of the vehicle. Failure to follow this instruction may result in serious injury to vehicle occupant(s).
NOTE: Do not scratch the pinch weld area. For minor scratches or exposed metal on the pinch weld, see manufacturer's recommendations.
3. If reinstalling the original windshield glass, remove the excess urethane adhesive and the windshield moulding.
