Tribute 4WD L4-2.5L Hybrid (2009)
6. Replace the engine support crossmember with improved service level crossmember.
Tightening Torque: Bolts - 66 lb-ft. (90 Nm), New nut - 129 lb-ft. (175 Nm)
NOTE:
This part is only applicable to 2009 vehicles produced on or before June 26, 2009, and will not correct any other symptom.
7. Install rear roll restrictor-to-crossmember through bolt.
Tightening Torque: 66 lb-ft. (90 Nm)
8. Install the lower transaxle insulator through bolt.
Tightening Torque: 85 lb-ft. (115 Nm)
9. Enable the vehicle high voltage electrical system according to MS3 on-line instructions or Workshop Manual (Section 01-13 HIGH-VOLTAGE
TRACTION BATTERY SYSTEMS DEPOWERING - HYBRID).
10. Verify repair.
PART(S) INFORMATION
WARRANTY INFORMATION
NOTE:
^ This warranty information applies only to verified customer complaints on vehicles eligible for warranty repair.
^ This repair will be covered under Mazda's New Vehicle Limited Warranty term.
^ Additional diagnostic time cannot be claimed for this repair.