Tribute 4WD L4-2.5L Hybrid (2009)
minutes.Make sure nothing is present on the passenger seat before carrying out the OCS system reset and nothing is placed on the seat during the
process.Make sure a minimum 8-second time period has passed after cycling the ignition switch ON before the carrying out the OCS system reset
process.
NOTE:If the first attempt to carry out the OCS system reset is unsuccessful, a second attempt must be made. If the second attempt is unsuccessful, a new
OCS system service kit must be installed.Carry out the OCS system reset active command.
2. The ignition switch must be cycled after the OCS system reset.
-
Cycle the ignition switch from ON to OFF.
All Seats
NOTE:The ignition switch must be cycled after the OCS system reset is successful.
1. Prove out the SRS as follows:
-
Turn the ignition key from ON to OFF. Wait 10 seconds, then turn the key back to ON and visually monitor the air bag warning indicator with
the air bag modules installed. The air bag warning indicator will light continuously for approximately 6 seconds and then turn off. If an SRS
fault is present, the air bag warning indicator will:
-
fail to light.
-
remain lit continuously.
-
flash at a 5 Hz rate (RCM not configured)
-
The air bag warning indicator may not light until approximately 30 seconds after the ignition switch has been turned from the OFF to the ON
position. This is the time required for the RCM to complete the testing of the SRS. If the air bag warning indicator is inoperative and a SRS
fault exists, a chime will sound in a pattern of 5 sets of 5 beeps. If this occurs, the air bag warning indicator and any SRS fault discovered must
be diagnosed and repaired.
-
Clear all continuous RCM and OCSM DTCs using a scan tool.
Front Seat Cushion Removal/Installation
FRONT SEAT CUSHION REMOVAL/INSTALLATION
NOTE:Seat equipped with power seat track shown, manual seat track similar.
Seat Cushion - Driver
