Tribute 4WD L4-2.5L Hybrid (2009)
1. Remove the rear seat cushion.
-
Position the seat cushion forward.
-
Release the locking tab and slide the rear seat cushion outward.
2. Unzip the cushion trim cover zipper.
CAUTION:Use care when separating the seat cushion trim cover from the hook-and-loop strips or the hook-and-loop strips may be torn from the seat
cushion foam pad.
3. Invert and remove the cushion trim cover.
4. Remove the 2 bolts and the cushion pivot upper link.
-
To assemble, tighten to 40 Nm {4.0 kgf-m, 30 ft-lbf}.
5. Remove the 2 cushion hinge floor bracket bolts and cushion support-to-floor bracket.
-
To assemble, tighten to 40 Nm {4.0 kgf-m, 30 ft-lbf}.
6. To assemble, reverse the disassembly procedure.
Driver Seat Cushion Disassembly/Assembly [Front]
DRIVER SEAT CUSHION DISASSEMBLY/ASSEMBLY
NOTE:Seat equipped with power seat track shown, manual seat track similar.
