Tribute 4WD L4-2.5L Hybrid (2009)
4. Remove the front wheel speed sensor harness from the retainer.
5. Remove the front wheel speed sensor harness-to-body bolt.
-
To install, tighten to 9 Nm {0.9 kgf-m, 80 in-lbf}.
6. Remove the front wheel speed sensor harness bolt.
-
To install, tighten to 15 Nm {1.5 kgf-m, 133 in-lbf}.
7. Remove the front wheel speed sensor bolt from the wheel knuckle.
-
To install, tighten to 9 Nm {0.9 kgf-m, 80 in-lbf}.
8. Remove the front wheel speed sensor.
NOTE:Clean off any foreign material that may have collected around the sensor before removal.
9. To install, reverse the removal procedure.
NOTE:Thoroughly clean the mounting surface.
