Tribute 4WD L4-2.5L Hybrid (2009)
2. Remove and discard the booster push rod clevis locking pin.
NOTE:The booster push rod clevis locking pin is a one-time use only part. Anytime the booster push rod clevis locking pin is removed, a new booster
push rod clevis locking pin should be used.
NOTE:Remove the clevis locking pin by squeezing the locking tabs and pulling outward on the opposite end.
3. Disconnect the electrical connectors and detach the harness retainers.
4. Remove the brake pedal bracket upper bolt.
-
To install, tighten to 23 Nm {2.3 kgf-m, 17 ft-lbf}.
5. Remove the brake pedal bracket upper and lower nuts.
-
To install, tighten to 23 Nm {2.3 kgf-m, 17 ft-lbf}.
6. Remove the 4 brake booster nuts.
-
To install, tighten to 23 Nm {2.3 kgf-m, 17 ft-lbf}.
7. Remove the brake pedal and bracket assembly.
-
Position the brake booster forward to allow the brake pedal and bracket assembly to clear the brake booster studs.
8. To install, reverse the removal procedure.
CAUTION:Do not press, pull or otherwise move the brake pedal while installing the brake pedal position (BPP) switch or the speed control deactivator
switch. These switches must be installed with the booster push rod attached to the brake pedal and with the brake pedal in the at-rest position. Installing
these switches with the brake pedal in any other position will result in incorrect adjustment and may damage the switches.
