Tribute 4WD L4-2.5L Hybrid (2009)
Backing Plate: Service and Repair
Brake Backing Plate Removal/Installation
BRAKE BACKING PLATE REMOVAL/INSTALLATION
1. Remove the rear wheel cylinder. See See: Wheel Cylinder/Service and Repair/Removal and Replacement.
2. Remove the brake flexible hose bracket bolt.
-
To install, tighten to 15 Nm {1.5 kgf-m, 133 in-lbf}.
3. Compress the parking brake cable conduit locking tabs and pull the parking brake cable assembly through the backing plate.
4. Remove the rear wheel hub. See - See: Maintenance/Wheels and Tires/Wheel Bearing/Service and Repair/Wheel Bearing Removal/Installation
[Rear Suspension] or - See: Maintenance/Wheels and Tires/Wheel Bearing/Service and Repair/Wheel Bearing Removal/Installation [Rear
Suspension].
5. Remove the 4 backing plate bolts and the backing plate.
-
To install, tighten to 85 Nm {8.5 kgf-m, 63 ft-lbf}.
6. To install, reverse the removal procedure.