Tribute 4WD L4-2.5L Hybrid (2009)
Parking Brake Control: Service and Repair
PARKING BRAKE CONTROL REMOVAL/INSTALLATION
1. Remove the front driver side door scuff plate and kick panel. See See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door
Panel/Service and Repair.
2. Release the parking brake cable tension. See See: Parking Brake Cable/Service and Repair/Procedures.
3. Remove the parking brake release handle bolt.
-
To install, tighten to 10 Nm {1.0 kgf-m, 89 in-lbf}.
4. Disconnect the parking brake warning indicator switch electrical connector and detach harness pin-type retainer from the parking brake control
cover.
5. Remove the 2 parking brake control bolts.