Tribute 4WD L4-2.5L Hybrid (2009)
1. Remove the hydraulic control unit (HCU). See - See: Antilock Brakes / Traction Control Systems/Hydraulic Control Assembly - Antilock
Brakes/Service and Repair.
2. Remove the 4 ABS module screws and the ABS module.
-
To install, tighten to 2 Nm {0.2 kgf-m, 18 in-lbf}.
3. To install, reverse the removal procedure.
4. Configure the ABS module. See See: Body and Frame/Body Control Systems/Body Control Module/Description and Operation/Module
Configuration.
5. Calibrate the ABS module. Follow the instructions on the scan tool.
NOTE:Vehicle must be on level ground and at a complete stand still during calibration.
