Tribute 4WD L4-2.5L Hybrid (2009)
Refrigerant Control Solenoid Valve: Service and Repair
Battery Zone Valve Removal/Installation
-
BATTERY ZONE VALVE REMOVAL/INSTALLATION - HYBRID
NOTE:The battery zone valve is not interchangeable with the passenger zone valve.
1. Remove the auxiliary climate control housing. See - See: Housing Assembly HVAC/Service and Repair/Removal and Replacement/Auxiliary
Climate Control Housing Removal/Installation.
2. Remove the 2 battery zone valve screws.
-
To install, tighten to 2 Nm {0.2 kgf-m, 18 in-lbf}.
3. Loosen the nuts and disconnect the battery zone valve tube-O fittings.
-
Discard the O-ring seals.
-
To install, tighten to 17 Nm {1.7 kgf-m, 150 in-lbf}.
4. Disconnect the electrical connector and remove the battery zone valve.
5. To install, reverse the removal procedure.
-
Install new O-ring seals.