Tribute 4WD L4-2.5L Hybrid (2009)
5. Reset the wheel and tire assembly on the turntable of the tire machine with the valve stem at the 2 o'clock position and the machine arm at the 12
o'clock position and dismount the inner bead from the wheel.
6. Remove the TPMS sensor in the following sequence.
a. Using a T10 Torx, remove the valve stem-to-TPMS sensor screw.
b. Carefully and firmly, pull the sensor straight down and separate it from the valve stem.
CAUTION:A new valve stem must be installed whenever the tire is dismounted or incorrect valve stem sealing may occur.
7. Using a suitable valve stem puller and a wood block, remove the valve stem.
CAUTION:Use care not to damage the wheel surface when removing the valve stem.
8. If the TPMS sensor is being reused, inspect the TPMS sensor for damage and install new parts as necessary.
NOTE:When installing a new wheel, always install a new valve stem and reuse the TPMS sensor from the previous wheel if possible. The TPMS will
not have to be trained if the sensor is reused.
