Tribute 4WD L4-2.5L Hybrid (2009)
Ignition Coil: Service and Repair
-
IGNITION COIL-ON-PLUG REMOVAL/INSTALLATION - 2.5L
1. Disconnect the 4 ignition coil electrical connectors.
2. Remove the 4 stud bolts and the ignition coils.
-
To install, tighten to 8 Nm {0.8 kgf-m, 71 in-lbf}.
NOTE:When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.
3. Inspect the coil seals for rips, nicks or tears. Remove and discard any damaged coil seals.
-
To install, slide the new coil seal onto the coil until fully seated at the top of the coil.
4. To install, reverse the removal procedure.
-
Apply a small amount of dielectric grease to the inside of the ignition coil boots before attaching to the spark plugs.
