Tribute 4WD L4-2.5L Hybrid (2009)
5. Disconnect the crankshaft position (CKP) sensor electrical connector.
6. Remove the bolts and the CKP sensor.
Installation
1. Install a 6 mm (0.23 in) x 18 mm (0.7 in) standard bolt.
CAUTION:Only hand tighten the bolt or damage to the front cover may occur.
2. Install a new CKP sensor and the bolts.
-
Do not tighten the bolts at this time.
NOTE:Whenever the crankshaft position (CKP) sensor is removed, a new one must be installed using the alignment tool supplied with the new part.
