Tribute 4WD L4-2.5L Hybrid (2009)
^
When reprogramming a PCM, IDS will always display the latest" calibration P/N available for that vehicle. If any calibration has been
revised/updated to contain new information for a new service concern/issue, it will also contain all previously released calibrations.
^
When performing this procedure, we recommend that a battery charger be installed on the vehicle battery and turned ON to a maximum charge of no
more than 20 AMPS to keep the vehicle battery up to capacity. If you exceed 20 AMPS, it could damage the VCM.
3. After performing the PCM reprogramming procedure, verify the repair by starting the engine and making sure there are no MIL illumination or
abnormal warning lights present.
NOTE:
^
If any DTCs should remain after performing DTC erase, diagnose the DTCs according to the appropriate Troubleshooting section of the
Workshop Manual.
^
After PCM reprogramming, it is no longer necessary to road test the vehicle to relearn" KAM (Keep Alive Memory).
CALIBRATION INFORMATION
NOTE:
It is not necessary to order a PCM part for this repair procedure.
WARRANTY INFORMATION
NOTE:
^
This warranty information applies only to verified customer complaints on vehicles eligible for warranty repair.
^
This repair will be covered under Mazda's New Vehicle Limited Warranty term for a Powertrain Component.
Additional diagnostic time cannot be claimed for this repair.
