Tribute 4WD L4-2.5L Hybrid (2009)
Impact Sensor: Removal and Replacement
Side Impact Sensor - First Row, B-Pillar Removal/Installation
-
SIDE IMPACT SENSOR - FIRST ROW, B-PILLAR REMOVAL/INSTALLATION
Removal
WARNING:If a vehicle has been in a crash, inspect the restraints control module (RCM) and the impact sensor (if equipped) mounting areas for
deformation. If damaged, restore the mounting areas to the original production configuration. A new RCM and sensors must be installed whether or not
the air bags have deployed. Failure to follow these instructions may result in serious personal injury or death in a crash.
WARNING:To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in serious
personal injury or death.
NOTE:The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a SRS fault.
NOTE:The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
NOTE:Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
NOTE:RH side shown, LH side similar.
1. Depower the system. See See: Air Bag(s) Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering And
Repowering.
2. Remove the B-pillar trim panel. See See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/B-Pillar Trim Panel
Removal/Installation.
3. Disconnect the side impact sensor electrical connector.
4. Remove the bolt and the side impact sensor.
WARNING:Always tighten the fasteners of the restraints control module (RCM) and impact sensor (if equipped) to the specified torque. Failure to do