Tribute 4WD L4-2.5L Hybrid (2009)
-
Pressure sensor hose for kinks and/or damage
-
Seat-related wiring harness and body wiring harness terminals and connectors for damage
15. Carry out a second OCS system reset. If the second attempt is unsuccessful, install a new OCS system service kit.
NOTE:The ignition switch must be cycled after the occupant classification sensor (OCS) system reset is successful.
16. Prove out the SRS as follows:
Turn the ignition key from ON to OFF. Wait 10 seconds, then turn the key back to ON and visually monitor the air bag indicator with the air bag
modules installed. The air bag indicator will light continuously for approximately six seconds and then turn off. If an air bag SRS fault is present,
the air bag indicator will either:
- fail to light.
- remain lit continuously.
- flash at a 5 Hz rate (RCM not configured).
The air bag warning indicator might not light until approximately 30 seconds after the ignition switch has been turned from the OFF to the ON
position. This is the time required for the RCM to complete the testing of the SRS. If the air bag indicator is inoperative and a SRS fault exists, a
chime will sound in a pattern of 5 sets of 5 beeps. If this occurs, the air bag warning indicator and any SRS fault discovered must be diagnosed and
repaired.
Clear all RCM and OCS module DTCs using a scan tool.
