Tribute 4WD L4-2.5L Hybrid (2009)
3. Install the OCS components to the seat cushion pan.
a. Install the pressure sensor onto the seat cushion pan bracket, making sure the retaining tab is completely engaged. When installed correctly, an
audible click will be heard and the pressure sensor will not be able to be removed from its bracket without disengaging the retaining tab.
b. Slide the ECU into the seat cushion pan bracket. The ECU must be correctly positioned and securely fastened in place. Failure to do so can set
a DTC in the restraints control module (RCM).
c. Install the rivets.
NOTE:When installing a service part occupant classification sensor, the seat wire harness pressure sensor electrical connector is not used.
NOTE:Make sure the pressure sensor hose is not kinked during installation.
4. Attach the seat cushion trim cover J-clips to the seat cushion pan.
5. Position the seat cushion and pan assembly to the seat track.
-
To aid in installation, recline the seat.
CAUTION:While positioning the seat cushion pan and occupant classification sensor (OCS) assembly, be careful not to damage any of the components.
Failure to follow these instructions may result in component damage and/or system failure.
6. Install the 4 seat track-to-cushion frame bolts.
-
Tighten to 25 Nm {2.5 kgf-m, 18 ft-lbf}.
