Tribute 4WD L4-2.5L Hybrid (2009)
Air Bag(s) Arming and Disarming: Service and Repair
Supplemental Restraint System (SRS) Deactivation And Reactivation
SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEACTIVATION AND REACTIVATION
Deactivation
WARNING:Never probe the electrical connectors on air bag, safety canopy or side air curtain modules. Failure to follow this instruction may result in
the accidental deployment of these modules, which increases the risk of serious personal injury or death.
WARNING:To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in serious
personal injury or death.
NOTE:The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a SRS fault.
NOTE:The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
All vehicles
1. Turn all vehicle accessories OFF.
2. Turn the ignition switch to OFF.
3. At the smart power distribution junction box (SPDJB), located at the RH side of the center console, remove the cover and the restraints control
module (RCM) fuse 32 (10A) from the SPDJB. For additional information, refer to the Wiring Diagram.
4. Turn the ignition ON and visually monitor the air bag indicator for at least 30 seconds. The air bag indicator will remain lit continuously (no
flashing) if the correct RCM fuse has been removed. If the air bag indicator does not remain lit continuously, remove the correct RCM fuse before
proceeding.
5. Turn the ignition OFF.
6. Disconnect the battery ground cable and wait at least one minute. See See: Starting and Charging/Battery/Service and Repair/Procedures/Battery
Disconnect.
WARNING:Always deplete the backup power supply before repairing or installing any new front or side air bag supplemental restraint system (SRS)
component and before servicing, removing, installing, adjusting or striking components near the front or side impact sensors or the restraints control
module (RCM). Nearby components include doors, instrument panel, console, door latches, strikers, seats and hood latches.Refer to the Description and
Operation portion of See: Description and Operation for the location of the RCM and impact sensor(s).To deplete the backup power supply energy,
disconnect the battery ground cable and wait at least 1 minute. Be sure to disconnect auxiliary batteries and power supplies (if equipped).Failure to
follow these instructions may result in serious personal injury or death in the event of an accidental deployment.
7. Using a 3-mm Allen wrench or a suitable tool, place it in the driver air bag module release hole on the underside of the steering wheel.
