Tribute 4WD L4-2.5L Hybrid (2009)
7. Connect the electrical connector(s) and wiring clips.
a. Connect the seat wire harness OCS electrical connector to the service part OCS electrical connector.
b. Install the two wiring clips on the wiring harness to the cushion pan.
c. If equipped with heated seats, connect the heated seat module electrical connector, install the wiring clip on the wiring harness to the cushion
pan, and connect the two cushion element electrical connectors.
d. Tie strap the unused seat wire harness pressure sensor electrical connector safely out of the way.
e. Tie strap all loose wire harnesses and electrical connectors safely out of the way.
8. Install the front passenger seat and repower the SRS. Do not prove out the system at this time. See See: Body and Frame/Seats/Service and Repair
.
9. Carry out the OCS system reset.
WARNING:Make sure the front passenger seat repair is complete, the seat and all attached components (head restraint, seat side shield, etc.) are
correctly assembled, and the seat is correctly installed to the vehicle before carrying out the System Reset. Failure to follow these instructions may result
in incorrect operation of the occupant classification sensor (OCS) system and increases the risk of serious personal injury or death in a crash.
WARNING:Install a new occupant classification sensor (OCS) system service kit as a complete assembly. Never install only part of the kit components.
Failure to follow this instruction may result in incorrect operation of the OCS system and increase the risk of serious personal injury or death in a crash.
